![]() It has been rectified on the later models after 1999. The common failure is the 01/90 fail code or the radio is just plain dead. ![]() This clamp puts to much pressure on the solder joint. Also, cut the middle finger off the metal clamp that presses down on it. ![]() Where the metal fingers clamp down the board you need to reflow the solder to this regulator if it has not already come undone. ![]() It should be U500 and its next to the audio IC. I talked to the local Motorola dealer and they said that programming these radios with older RSS than they had last been programmed with would indeed corrupt the codeplug".Īre you having a problem with the control heads on your MCS2000? There is a bulletin out the 5 volt regulator is falling off of the board in the radio (not the head). ![]() It corrupted the codeplug and this brand new radio had to be sent back to the big M. GM900/MC900/GM1100/GM1200/GM2000/MCX1200/MCS2000/MCX2000/MC2100 GM900/MC900/GM1100/GM1200/GM2000/ MCX1200/MCS2000/MCX2000/MC2100Īll of these radios belong to the same family and are covered under the same service manual, hence, most of the information should be common to all models.īEWARE: Take note of the following we received, "It seems after attempting to write the codeplug of a NEW MCS2000, I got a fail message on the screen. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |